finishing installation
we answer "n" to the 16-bit drivers question, then select the default logical node number QNX gives us, and after pressing two or three more times the enter key, we get to the next screen...
last step
we select the timezone, and the number of consoles, and answer y to the mouse question...
I haven't configured the networking, so I answered "n" to that question. That takes us to...
installation complete
rebooting (we can type
shutdown in the prompt or close MESS and reopen it)
logging in
installing photon microGUI
we do this by inserting the Photon MicroGUI Disk 1 and typing
install /dev/fd0. There is no need to mount the floppy. In fact, you'll get an error stating that the filesystem in the disk is corrupted if you try...
more installing photon...
Change the disks when asked
configuring photon display
we load photon by typing
ph in the prompt
More in part 3...
